Rsync –v –r –h –size-only –progress /share/USBDisk1/MyMedia/ /share/Qmultimedia/ If you wished for example to copy the backed up /MyMedia/ folder onto your QNAP server under the /Qmultimedia/ folder you would run the following command. This is good if you wish to play around with the options. n dry run – simulates the copy without actually transferring any files. –progress displays live transfer details such as the percentage copied and the speed of the transfer If you have to abort and later resume your synchronisation, this option will enable you to skip the files that have already been copied to your QNAP server. –size-only – recommended otherwise rsync will use dates to check for file differences. r recursive scanning and copying – scans and copies all sub-directories vv verbose output with additional information v verbose output – displays syncing information Rsync comes with a number of option attributes but we will only list the ones of interest to our task.Ĭommand: rsync SOURCE… The external USB device will be located in the /share/USBDisk1/ directory. Your QNAP device keeps symbolic links to all the folders within the /share/ directory. Rsync is a Linux tool that allows you to synchronise directories together. Login using your QNAP ‘admin‘ account, as this is the only account accepted by QNAP under Telnet. Once connected you should be prompted for a login in a screen that is not unlike the Windows Command Prompt.Once you have setup Putty, open the session. In Putty setup your Putty Configuration to look like this, but obviously replace the IP address with that of your QNAP server.From now on I will assume that is what you are using. So if you don’t have a client, download Putty and install it. I recommend the very popular client known as Putty ( ). Now we will need to connect to your QNAP server using a Telnet client.On the Remote Login make sure the Telnet connection is selected. In the QNAP administrator webpage select Network Services > Remote Login.If you already are familiar with using Telnet or SSH to connect to your QNAP server you can skip this and go to Part II of this article. Now we are going to turn on the Telnet remote log-in of the QNAP server.If everything is okay your USB disk should be shown in the web form.Go to External Device and then select USB Disk.Login using your administrator ( admin) account. Web browse to your QNAP administration page, by default it is at.Plug in your external USB device into a USB socket at the back of the QNAS server and turn the USB device on (if needed).Turn on your QNAS server and wait for it to boot.This utility covered all my needs quite well and so below I will explain how to use it with an external USB device and a QNAP NAS server. In the past I have found it unreliable and I also preferred the manual control of using the Linux command line.įortunately the QNAP server comes with the handy command known as rsync. One of the problems though was trying to work out an easy away to transfer the 750 GB of data from the USB device over to the NAS server without using the QNAP Backup feature. This is something I would recommend to everyone do, even those with NAS devices which run with multiple drives. Lucky I had all the QNAP data stored on a secondary, dumb USB hard drive so no data was lost. Eventually I gave up and restarted from scratch. No amount of partition fixing or recovering would enable it to mount. For some reason the file partition holding all the data became so corrupt that the QNAP firmware would refuse to even mount the drive. Recently I was forced to format my QNAP TS-109 and reinstall the firmware.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |